personal burn injuries do not start your engine with the air
cleaner removed and do not remove it while the engine is running.
408
2011 F-150 (f12) Owners Guide, 3rd Printing USA (fus)
Maintenance and Specifications
Changing the air filter element 1. Locate the mass air flow sensor electrical connector on the air outlet tube. This connector will need to be unplugged.
2. Reposition the locking clip on the connector (connector shown from below for clarity), squeeze the connector and pull it off of the air outlet tube.
3. Clean the area around the air tube to air cover connection to prevent debris from entering the system and then loosen the bolt on the air tube clamp so the clamp is no longer snug to the air tube. It is not necessary to completely remove the clamp. 4. Pull the air tube off from the air cleaner housing.
2011 F-150 (f12) Owners Guide, 3rd Printing USA (fus)
409
Maintenance and Specifications
5. Release the three clamps that secure the cover to the air filter housing. Push the air filter cover toward the center of the vehicle and up slightly to release it.
6. Remove the air filter element from the air filter housing. 7. Install a new air filter element.
8. Replace the air filter housing cover and secure the clamps. Be careful not to crimp the filter element edges between the air filter housing and cover and ensure that the tabs on the edge are properly aligned into the slots. 9. Slip the air tube onto the air filter housing and tighten the air-tube clamp bolt snugly, but do not overtighten it.
410
2011 F-150 (f12) Owners Guide, 3rd Printing USA (fus)
Maintenance and Specifications
10. Reconnect the mass air flow sensor electrical connector to the outlet tube. Make sure the locking tab on the connector is in the “locked” position (connector shown from below for clarity).
Note: Failure to use the correct air filter element may result in severe engine damage. The customer warranty may be void for any damage to the engine if the correct air filter element is not used.
VEHICLE STORAGE If you plan on storing your vehicle for an extended period of time (30 days or more), refer to the following maintenance recommendations to ensure your vehicle stays in good operating condition. All motor vehicles and their components were engineered and tested for reliable, regular driving. Long term storage under various conditions may lead to component degradation or failure unless specific precautions are taken to preserve the components. General • Store all vehicles in a dry, ventilated place. • Protect from sunlight, if possible. • If vehicles are stored outside, they require regular maintenance to
protect against rust and damage.
Body • Wash vehicle thoroughly to remove dirt, grease, oil, tar or mud from exterior surfaces, rear-wheel housing and underside of front fenders. See the Cleaning chapter for more information. • Periodically wash vehicles stored in exposed locations. • Touch-up raw or primed metal to prevent rust. • Cover chrome and stainless steel parts with a thick coat of auto wax
to prevent discoloration. Re-wax as necessary when the vehicle is washed. See the Cleaning chapter for more information.
• Lubricate all hood, door and trunk lid hinges, and latches with a light
grade oil. See the Cleaning chapter for more information.
411
2011 F-150 (f12) Owners Guide, 3rd Printing USA (fus)
Maintenance and Specifications • Cover interior trim to prevent fading. • Keep all rubber parts free from oil and solvents. Engine • The engine oil and filter should be changed prior to storage, as used • Start the engine every 15 days. Run at fast idle until it reaches normal • With your foot on the brake, shift through all the gears while the
engine oil contain contaminates that may cause engine damage.
operating temperature.
engine is running.
Fuel system • Fill the fuel tank with high-quality fuel until the first automatic shutoff
of the fuel pump nozzle.
Note: During extended periods of vehicle storage (30 days or more), fuel may deteriorate due to oxidation. Add a quality gas stabilizer product to the vehicle fuel system whenever actual or expected storage periods exceed 30 days. Follow the instructions on the additive label. The vehicle should then be operated at idle speed to circulate the additive throughout the fuel system. Cooling system • Protect against freezing temperatures. • When removing vehicle from storage, check coolant fluid level. Confirm there are no cooling system leaks, and fluid is at the recommended level.
Battery • Check and recharge as necessary. Keep connections clean. • If storing your vehicle for more than 30 days without recharging the battery, it may be advisable to disconnect the battery cables to ensure battery charge is maintained for quick starting.
Note: If battery cables are disconnected, it will be necessary to reset memory features. Brakes • Make sure brakes and parking brake are fully released. Tires • Maintain recommended air pressure.
412
2011 F-150 (f12) Owners Guide, 3rd Printing USA (fus)
Maintenance and Specifications
Miscellaneous • Make sure all linkages, cables, levers and pins under vehicle are • Move vehicles at least 25 feet (8 m) every 15 days to lubricate
covered with grease to prevent rust.
working parts and prevent corrosion.
window surfaces.
during storage (mice/squirrel nests).
Removing vehicle from storage When your vehicle is ready to come out of storage, do the following: • Wash your vehicle to remove any dirt or grease film build-up on • Check windshield wipers for any deterioration. • Check under the hood for any foreign material that may have collected • Check the exhaust for any foreign material that may have collected • Check tire pressures and set tire inflation per the Tire Label. • Check brake pedal operation. Drive the vehicle 15 ft (4.5 meters) back • Check fluid levels (including coolant, oil and gas) to make sure there • If the battery was removed, clean the battery cable ends and inspect. If you have any concerns or issues, contact your authorized dealer.
are no leaks, and fluids are at recommended levels.
and forth to remove rust build-up.
during storage.
413
2011 F-150 (f12) Owners Guide, 3rd Printing USA (fus)
Maintenance and Specifications
MOTORCRAFT PART NUMBERS
Component
Air filter element Battery Oil Filter
Spark plugs
3.7L V6
engine
5.0L V8
engine
6.2L V8
engine
3.5L V6
EcoBoost™
engine
FA-1883
FA-1883
FA-1883
FA-1883
BXT-65-750 BXT-65-750 BXT-65-750 BXT-65-750
FL-500-S
FL-500-S
FL-820-S
FL-500-S
1 For spark plug replacement, see your authorized dealer. Refer to scheduled maintenance information for the appropriate intervals for changing the spark plugs. Replace the spark plugs with ones that meet Ford material and design specifications for your vehicle, such as Motorcraft威 or equivalent replacement parts. The customer warranty may be void for any damage to the engine if such spark plugs are not used.
414
2011 F-150 (f12) Owners Guide, 3rd Printing USA (fus)
Maintenance and Specifications
– – • • •
•
–
• • •
•
威
威 •
威 •
威 •
威 •
威 •
威 •
威 •
威 •
™
415
2011 F-150 (f12) Owners Guide, 3rd Printing USA (fus)
Maintenance and Specifications
威
—
威
威
威
—
—
• •
威 •
威 •
威
威
™