BoostCruising [Powered by Invision Power Board]

Posted by: s13rb Dec 23 2006, 05:25 PM

My girlfriend has an 88 Nissan Skyline R31 Ti, that will start cold and and once it reaches running temprature it stops and won't start again until it cools..fuel pump is pumping fine, i have replaced the head with a re-co head, head gasket, water temp sensor, tryed another ECU, another inlet manifold with all new idle steper, fuel preasure regulator air regulator and all but still it keeps on doing the same thing.. im thinking now oil preasure sender..

any feed back would be really appreciated

cheers Chris..

Posted by: 321cya Dec 23 2006, 07:19 PM

QUOTE(s13rb @ Dec 24 2006, 11:25 AM) [snapback]1280607374[/snapback]

My girlfriend has an 88 Nissan Skyline R31 Ti, that will start cold and and once it reaches running temprature it stops and won't start again until it cools..fuel pump is pumping fine, i have replaced the head with a re-co head, head gasket, water temp sensor, tryed another ECU, another inlet manifold with all new idle steper, fuel preasure regulator air regulator and all but still it keeps on doing the same thing.. im thinking now oil preasure sender..

any feed back would be really appreciated

cheers Chris..

try the dizzy as the optical sensor (inside the dizzy) is know 4 shittin its self or try the coil

oil pressure sensor wont cause that its only 4 the guage on the dash

Posted by: s13rb Dec 23 2006, 09:00 PM

ok i have tryed new coil new dizzy . and ignition module..

still no good??

Posted by: SIKUNIT Dec 24 2006, 02:10 AM

New or s/hand dizzy???

Posted by: s13rb Dec 25 2006, 11:35 PM

secondhand but it was off a running car

Posted by: cilkorules Dec 30 2006, 02:10 PM

i had this same problem i eventually opened the dizzy cap and found that the screw for the rotor buttton was loose and almost falling off... good to have a look anyways, all u need is a phillips head screw driver

Printable Version of Topic