My Toolbox

RB25 Performance Parts.brand New Stage 2 Race HEAD With Tomei CAMS

Underwood QLD 4119 (Brisbane South)

RB25 Performance Parts.brand New Stage 2 Race HEAD With Tomei CAMS
$100 Negotiable
This item was listed over six months ago, please confirm with the seller whether it is still available for sale.

Brief Details

Price
$ 100 Negotiable
Condition
Used
Delivery
PickUp
Seller
bigboss
Updated
over a month ago
Views
2585
Bumps
1

Sellers Description

Hi all,

I have a few bitz from a Rb25det race engine that i never completed & it has since
been laying around my shed for a while.
I need to move them on.
List is as follows,

1- Rb25det Stage 2 Race head.
I have had this built by a professional shop and it is still brand new wrapped up in plastic.
Head is off a series 2 R33 Gts-t & suits any Rb25det bottom end.
Chemical clean
Preasure & crack tested
K-line guides,multi angle valve job
Replaced super tech seals
High lift spring & retainer kit with 9.5mm lift caability
260cfm Race port for maximium flow.
Included in the price is a pair of Tomei Poncams.
Inlet is 256mm with 8.5mm lift
Exhaust is 264mm with 8.5mm lift
Also included in the packege is an adjustable Hks cam gear.
With this Poncam set up you can still retain the factory VCT which is worth using as it will help with boost coming on around 500rpm earlier.The Poncams will give you greater low to mid range torque.
This head is brand new,the Tomei cams and Hks cam gear have done around 1,200klms in a previous set up,Cams are in as new condition.
I can separate the cams & cam gear from the head but prefer to sell together.
Complete head set up with Cams & adj cam gear $2600

2-Rb25det Stroker bottom end 2.7l.
*Components have been in workshop sitting around & has some surface rust on Block,
small amount on crank and some surface rust on the rods (as pictured)
The block is Rb25det that has been mechined to 87mm
The block was originally mechined at Jack bros Racing in Slacks creek along with the Rb26 Gtr crank & girdle.
Pistons are JE from memory..87mm. New Total rings were fitted.
Rods are Crower.
After a small engine falure on the dyno (bearings) the bottom end was then stripped
down and re machined by JHH Racing where it has since been sitting around in my shed in its current unassembled state.
Odviously you will need to freshen up the bits again.
Whole bottom end,Block,pistons,rods,Gtr crank & matching Gurdle $650

3-Rb25det cranks & girdle.These were extracted from 2 good engines but didnt end up
getting used.They will need a freshen up as have some surface rust on them
$150 each

4- This set up came out of a running Rb25det
R33 Gtr injectors in Rb25det fuel rail with harness
R33 Gtr injector resistor pack
Z32 airflow meter
Dont want to seperate at this stage
Complete upgrade kit $375

5-Nismo Rb25det Engine mounts (left & right). Again done around 1,200klms & comes
with the factory alloy brackets.Mounts are like new $230 pair (posted)

6-R33 Gts-t dash cluster. Showing 82,000klms $120

7- Rb25det starter motor $60

8- Rb25 Rocker covers & valley cover.
Professionally powder coated.Complete set $125

Im located on Brisbane southside.
Pick up welcome
For interstate buyers i can post or help with organising a courier for you at your
cost.
Please give me a call to make a time to view or if you have any questions.
XXXX-XXX-XXX
Cheers!

Sellers Details

My Favourite Ads
  • Save your favourite ads to create a shortlist
Recently Viewed Ads
  • You have no recently viewed ads
Loading...
x